Zanussi Electrolux ZRB 3225 X, User Manual

16

Door reversal directions

1. Disconnect from the electricity supply.

2. Gently lay the fridge/freezer on its back with the

top held away from the floor by 5-8 cm (2-3
inches) of packing;

3. Remove the ventilation grill (D).

4. remove the bottom hinge (E) by unscrewing its

fixing screws;

5. Remove the freezer door by releasing it from the

middle hinge (H).

6. Unscrew the middle hinge.

7. Remove the fridge door by releasing it from the

top hinge pin (G).

8. Remove the pin then mount these on the side,

after having removed the small plugs which
should then be fitted on the opposite side.

9. reassemble the door;

10. using a 10 mm spanner, unscrew the hinge pin

(E) and reassemble it on the opposite side of the
hinge;

11.Refit the fridge door and replace the middle hinge

to the left hand side.

12.reassemble the lower hinge (E) on the opposite

side, using the screws previously removed. Slide
the hole cover (F) out of the ventilation grille (D)
by pushing it in the direction of the arrow and
reassemble it on the opposite side;

13.refit the ventilation grille (D), clipping it into place;

14. Unscrew the handles. Refit them on the opposite

side after having pierced the plugs with a punch.
Cover the holes left open with the plugs supplied
in the documentation pack.

The doors can be aligned by adjusting the middle
hinge.

The middle hinge can be adjusted horizontally, after
having slackened the two screws with a screwdriver.

Important

After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer on a low setting.

G

H

F

F

D

F

F

E

E

D594

Rear spacers

In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure.

Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.

PR228