12
cleaned.
11. At the end of the programme
All drying programmes end with a 10
minute cooling phase.
You may remove the laundry after this
phase. The lights Filter and Empty
Tank, illuminate.
If the laundry is not removed at the end
of the cycle, the dryer performs an
anti-creasing phase (duration: 30 min-
utes maximum). If you do not remove
the laundry, the dryer will stop auto-
matically at the end of the anti-creasing
phase.
The Lights
Filter
and The
Empty Tank
remain lit and the buzzer sounds for 2
minutes. Turn the programme selector
dial to “Off” to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out anoth-
er wash, close the water tap. Leave
the door open to prevent the formation
of mildew and unpleasant smells.
Turn the programme selector dial to
“Off”; all the lights go out. The appli-
ance is switched off.
12. Remove the laundry.
If you open and then close the door
before turning the selector dial to“Off”
all the lights corresponding tothe phas-
es making up the performed pro-
gramme come on.
After each use
• Clean the filters.
• Empty the water reservoir.
Modifying the programme
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to “Off”. Select
the new programme and press the
Start button.
