Zanussi 2222 119-57 ZI 9121 F, Instruction Booklet

8

Defrosting

When the frost has reached a thickness of up to

4mm it can be removed using the ice scraper

provided with the appliance. During this operation it

is not necessary to disconnect the appliance from

the mains and remove the food. Never use metal

tools for this operation.
For complete defrosting (once or twice a year)

proceed as follows:
-  turn the thermostat control knob to the ÇOFFÈ

position (O) or disconnect the appliance from the

mains.

-  Remove any food from inside the freezer , wrap it

in several sheets of newspaper and store in a

cool/dry place.

-  Leave the door open and insert the ice scraper

under the channel in the centre of the lower part

of the appliance; place a low-sided container

beneath the scraper to collect the water (see fig.).

-  Clean and dry thoroughly.
-  Replace the scraper in one of the drawers .
-  Reconnect the appliance to the mains or reset

the thermostat control knob to the normal

operating position.

-  After letting the appliance run for at least two

hours in fast freeze mode, replace the previously

removed food into the compartment.

Important 

A temperature rise of the frozen food packs, during

defrosting, may shorten their safe storage life.

D068

17

Electrical connections

Any electrical work required to install this appliance

should be carried out by a qualified electrician or

competent person.

WARNING: THIS APPLIANCE MUST BE

EARTHED.
The manufacturer declines any liability should

this safety measure not be observed.

If the plug that is fitted to your appliance is not

suitable for your socket outlet, it must be cut off and

the appropriate plug fitted.
Remove the fuse from the cut off plug. 
The cut off plug should then be disposed of to

prevent the hazard of shocks in case it should be

plugged into a 13amp socket in another part of your

home.

Important

The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow        - Earth
Blue                              - Neutral
Brown                           - Live

If you fit your own plug, the colours of the wires in

the mains lead of your appliance may not

correspond with the markings identifying the

terminals in your plug, proceed as follows:

Connect the Green and Yellow (earth) wire to the

terminal in the plug which is marked with the letter
ÇEÈ or the earth symbol 

or coloured green and

yellow.
Connect the blue (neutral) wire to the terminal in the

plug which is marked with the letter ÇNÈ or coloured

black.
Connect the brown (live) wire to the terminal in the

plug which is marked with the letter ÇLÈ or coloured

red.
The plug moulded onto the lead incorporates a fuse.

D207

GREEN & YELLOW

13 AMP. FUSE

BROWN

CORD CLAMP

BLUE

13 AMP

For replacement, use a 13amp BSI362 fuse. Only

ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is

lost. The cover/carrier is indicated by the coloured

insert at the base of the plug.
A replacement cover/carrier must be obtained from

your local Zanussi Service Force Centre.

This appliance complies with the E.E.C. Directive

No. 87/308 of 2.6.87 relative to radio interference

suppression.

This appliance complies with the following

E.E.C. Directives:

- 

73/23 EEC of 19.2.73

(Low Voltage Directive)

and subsequent modifications;

- 

89/336 EEC of 3.5.89 

(Electromagnetic

Compatibility Directive) and subsequent

modifications.

Please ensure that when the appliance is

installed it is easily accessible for the engineer in

the event of a breakdown.