Zanussi 916098950, User Manual

WARNING! Deactivate the appliance before carrying out any check.

In case of major problems, the acoustic signals operate, the display shows an error code and
the 

 Start/Pause button may flash continuously:

Error code

Possible cause

Remedy

E5A

Appliance motor overloaded.

Too much laundry or entrap in the

drum.

The programme was not completed.

Remove the laundry from the drum,

set the programme and restart the cy-

cle.

E97

Internal fail. No communication be-

tween electronic elements of the ap-

pliance.

The programme was not finished

properly or the appliance stoped too

early. Switch the appliance off and on

again.

If the error code appears again, con-

tact the Authorised Service Centre.

EH0

The mains supply is unstable.

When the appliance is showing EH0,

please wait until main supply is stable

than press start. If the appliance

pause the cycle without any indication

then press the cycle start. If the warn-

ing will occur check the power cord /

socket integrity or main supply.

If the display shows other error codes, deactivate and activate the appliance. If the problem continues,

contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.

TROUBLESHOOTING

Problem

Possible solution

You cannot activate the appliance.

Make sure that the mains plug is connected to

the mains socket.

Check fuse in fuse box (domestic installation).

The programme does not start.

Press Start/Pause.

Make sure that the appliance door is closed.

The appliance door does not close.

Make sure that the installation of the filter is cor-

rect.

Make sure that the laundry does not catch be-

tween the appliance door and the rubber seal.

The appliance stops during operation.

Make sure that the water container is empty.

Press Start/Pause to start the programme again.

16