Care and cleaning
Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the glass-ce-
ramic cause no effect on how the appli-
ance operates.
To remove the dirt:
1.
–
Remove immediately:
melted plastic,
plastic foil, and food with sugar. If not,
the dirt can cause damage to the appli-
ance. Use a special scraper for the
glass . Put the scraper on the glass sur-
face at an acute angle and move the
blade on the surface .
–
Remove after the appliance is suffi-
ciently cool:
limescale rings , water
rings, fat stains, shiny metallic discolora-
tions. Use a special cleaning agent for
glass ceramic or stainless steel.
2.
Clean the appliance with a moist cloth and
some detergent.
3.
At the end
rub the appliance dry with a
clean cloth.
Troubleshooting
Problem
Possible cause
Remedy
You cannot activate the appliance
or operate it.
The appliance is not connected to
an electrical supply or it is con-
nected incorrectly.
Check if the appliance is correctly
connected to the electrical supply
(refer to connection diagram).
Activate the appliance again and
set the heat setting in less than 10
seconds.
You touched 2 or more sensor
fields at the same time.
Touch only one sensor field.
There is water or fat stains on the
control panel.
Clean the control panel.
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds when
the appliance is deactivated.
You put something on one or
more sensor fields.
Remove the object from the sensor
fields.
The appliance deactivates.
You put something on the sensor
field
.
Remove the object from the sensor
field.
The residual heat indicator does
not come on.
The cooking zone is not hot be-
cause it operated only for a short
time.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
The Automatic Heat Up function
does not operate.
The cooking zone is hot.
Let the cooking zone become suffi-
ciently cool.
The highest heat setting is set.
The highest heat setting has the
same power as the Automatic Heat
Up function.
You decreased the heat setting
from
.
Start from
and only increase the
heat setting.
You cannot activate the outer
ring.
Activate the inner ring first.
22
www.zanussi.com
Summary of Contents for 949 594 006 01
Page 12: ...Montage min 50mm min 500mm 490 1 mm 750 1mm R 5mm 55mm min 12 mm min 20 mm 12 www zanussi com ...
Page 39: ...Montage min 50mm min 500mm 490 1 mm 750 1mm R 5mm 55mm min 12 mm min 20 mm 39 www zanussi com ...
Page 52: ...Montage min 50mm min 500mm 490 1 mm 750 1mm R 5mm 55mm min 12 mm min 20 mm 52 www zanussi com ...
Page 55: ...55 www zanussi com ...
