7
Electronic programmer
1.
Push button for selecting a function
2.
Decreasing control button
3.
Increasing control button
4.
Display
5.
Cooking Duration pilot lamp
6.
End of cooking pilot lamp
7.
Minute minder pilot lamp
8.
Time of day pilot lamp
The oven will work only if the time of day has been set.
Moreover, the oven can also be operated without any programme.
Setting the time of day
When the power supply is switched on, or after a power failure, the Time
of day pilot lamp will flash on the display.
To set the correct time of day:
1.
press button or .
2.
After the setting is carried out, wait for 5 seconds: the Time of day
pilot lamp will go out and the display will show the set time. The
appliance is ready for use.
To reset the correct time of day:
1.
press button
repeatedly to select the Time of day function. The
relevant pilot lamp will start flashing. Then proceed as described
above.
The time of day may be reset only if no automatic function (cook
duration
or end of cooking
) has been set.
Cooking Duration function
Thanks to this function, the oven will automatically switch off at the end
of a programmed cooking duration time. Place food in the oven, select
a cooking function and adjust the cooking temperature. Press button
repeatedly to select the Cooking Duration function. The relevant pilot
lamp will start flashing. Then, proceed as follows:
To set the duration time:
1.
press button or .
2.
After the setting is carried out, wait for 5 seconds: the "Cooking
Duration" pilot lamp will come on and the display will revert to
the time of day.
3.
When cooking time is over, the oven will be switched off automatically
and an acoustic alarm will be heard, while the pilot lamp will start
flashing. Turn the oven function and the thermostat control knob to
zero.
To switch off the acoustic alarm, press any button.
NOTE:
when
doing this operation, the oven will be operated again, therefore,
remember to turn the oven function and the thermostat control knob
to zero at the end of the cooking time.
To cancel the duration time:
1.
Press button
repeatedly to select the Cooking Duration function.
The relevant pilot lamp will flash and the display will show the
remaining cooking time.
2.
Press button until the display shows 0:00. After 5 seconds
the pilot lamp will go out and the display will revert to the time of
day.
4
5
1
2
3
6
7
8
FO 2571
Fig. 7
Summary of Contents for BMF810
Page 1: ...BUILT IN OVEN BMF 810 INSTRUCTION BOOKLET IL ...
Page 2: ...2 ...
