15
The manufacturer disclaims any
responsability should all the safety
measures not be carried out.
Fig. 14
Fig. 13
Fig. 12
Securing the Oven to the
Cabinet
- Fit the appliance into the cabinet recess.
- Open the oven door and secure the oven to the kitchen
cabinet with four wood screws, which fit the holes
provided in the oven frame
(Fig.12-13).
- When installing an electric plate hob over the oven,
the hob's electrical connection and the oven's one
have to be carried out separately, for security reasons
and to let the oven be taken off the unit easier, if
necessary.
Electric Connection
Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load;
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the double pole switch used for the electrical
connection can be easily reached with the appliance
built in the forniture unit.
The appliance is supplied with connection cable provided
with plug. The plug has to be fitted into a proper socket.
In case of a direct connection to the mains, it is necessary
that you install a double pole switch between the appliance
and the electricity supply, with a minimum gap of 3 mm.
between the switch contacts and of a type suitable for the
required load in compliance with the current rules.
The connection cable has to be placed in order that, in
each part, it cannot reach a temperature 50 °C higher than
the room temperature.
Should the supply cable need to be replaced, use only
the following cable types:
- H05 RR-F; - H05 VV-F;- H07 RN-F; -H05 RN-F;
- H05 BB-F; - H05V2V2-F (T90).
After the connection is carried out, test the heating
elements for about 3 minutes.
Terminal block
The oven has an easily accessible terminal block, which is
meant to work with an electric single-phase rate of 230 V
(Fig. 14).
FO 0039
FO 0986
FO 2159
