Zanussi CH 6029 GR, Instruction Booklet

11

INSTALLING THE COOKER HOOD

Please ensure that when the appliance is
installed it is easily accessible to an 
engineer in the event of a breakdown.

All installations must comply with the 
local authorities requirements for the
discharge of exhaust air.

Incorrect installation may affect the 
safety of this cooker hood.

Installation Requirements

Before fitting the hood beneath any type
of canopy or wall cabinet, ensure that 
the housing is firmly fixed to the wall in
accordance with the manufacturer’s 
instructions.

If it is necessary to fix the housing for the
canopy to a hollow construction plaster or 
partition board structure then it should be 
sufficiently reinforced to be quite rigid in the 
area of the cabinet housing fixings.

Ducting

The ducting must be fire retardant 125mm (5 ins) 
in diameter and the length should be no
more than:
3 metres with one 90

0

bend

2 metres with two 90

0

bends

Bends of more than 90

0

will reduce the 

efficiency of the hood and reduce the airflow.

Clearance Height

The cooker hood is designed to be fitted over 
a cooking appliance at the clearance heights 
stated, providing the maximum output of the 
appliance beneath does not exceed the 
maximums quoted in the Technical Specifications.

If the output of the appliance below the
cooker hood exceeds the maximum outputs 
quoted in the Technical Information, please 
refer to the cooker appliance manufacturer’s 
installation instructions.