Zanussi CH 6029 GR, Instruction Booklet

A minimum clearance height of 650mm 
(25

1

/

2

”) is required when installed above a 

built-in electric hob, or 700mm (27

1

/

2

”) when 

installed above a built-in gas hob.  

A minimum clearance height of 685mm (27”) 
is required when installed above a slot-in 
electric cooker, or 787mm (30

1

/

2

”) when 

installed above a slot-in gas cooker.

When installed between adjoining wall 
cabinets, the wall cabinets must not overhang 
the hob and the distance between the 
underside of the cabinet and the worktop must 
be 450mm.  If the height of the wall cabinet is 
less than 450mm, a gap of 50mm must be 
maintained either side of the hob.

This cooker hood must not be installed 
above a cooking appliance with a high
level grill.

Unpacking

The fittings supplied to install this cooker 
hood can be found with the instruction book 
inside the packaging.
120 - 125 mm ducting collar

K

Fitting the Cooker Hood into 
the Housing/Canopy

The hood is fixed to the housing using the
screw holes located around the base of the
casing. Access to the screw holes will
require the removal of the metal grille panel.

Positioning the Cooker Hood

Measure the underside of the canopy or
kitchen cabinet to mark the position for the
cut-out. The cut-out measurement should be:
- 497mm (19 5/8”) wide
- 259mm (10 1/4”) deep

Check the position of the hole is correct
with the measurements above before
making the cut-out.

12

A: Built-in Electric Hob: 

650mm minimum clearance

B: Built-in Gas hob:

700mm minimum clearance

C: Slot-in Electric Cooker:  685mm minimum clearance
D: Slot-in Gas Cooker: 

787mm minimum clearance

Hob

•

•

••

•

•

•

•
•

•

B

65

ø 125

A

≥

13