www.zanussismallappliances.fr www.zanussismallappliances.be www.zanussismallappliances.nl
31
Internal cleaning: procedure
Before using the appliance for the first time, clean
the inside of the machine by running 2 internal
rinsing cycles with cold water only in order to
remove any dust or residue contained in the
device.
Internal rinsing of the device is also recommended
after a long period of non-use.
Plugging in the appliance
Unwind the appliance's power cord and plug the
plug into a power outlet.
Preparation
Lift the lever and insert an empty adapter (without
capsules orcoffee). Lower the lever to close. Place
a large cup (min. 250 ml) on the removable grid.
Switching on the appliance
Press the ON/OFF button to switch on the
appliance.
Preheating phase
The 3 control buttons light up to indicate that the
appliance is in preheating mode. The warm-up
time is approximately 45 seconds.
Starting the internal rinsing cycle
Press the small and large cup buttons
simultaneously to start the internal rinsing cycle.
End of procedure
Lift the lever and remove the empty adapter
(without capsules or coffee). Lower the lever to
close.
Important
Do not interrupt the internal cleaning
procedure if it is started.
Check that water the tank is filled to the
"MAX" level and correctly set to avoid any
risk of water leakage.
Make sure to close the lever before pressing
the buttons.
Always make sure to put a cup with a
minimum capacity of 250ml on the drip grid
before starting the internal rinsing procedure.
