11
INSTALLING THE COOKER HOOD
Please ensure that when the appliance is
installed it is easily accessible to an
engineer in the event of a breakdown.
All installations must comply with the local
authorities requirements for the discharge of
exhaust air.
Incorrect installation may affect the safety of
this cooker hood.
Installation Requirements
Before installation check the wall to which the
cooker hood is to be fitted for electric cables,
water pipes or gas.
This cooker hood is designed to be fixed to any rigid
vertical surface over a cooking area, and can be used in
the extraction (ducted to the outside) or recirculation
mode (internal recycling).
The installation work must be undertaken by a qualified
and competent person. The manufacturer disclaims any
responsibility for damages due to incorrect installation
of the cooker hood or if the hood is not installed in
compliance with relevant regulations controlling this type
of installation.
The CWH 6065/9065 is Supplied with the
Following Components for Installation:
1.
A canopy (C), including controls, worktop
illumination and fan unit.
2.
A telescopic chimney stack consisting of:
•
U-shaped upper section (S)
•
U-shaped lower section (I)
•
2 recirculation venting grilles (G)
3.
1 recirculation ducting spigot (F)
4.
1 extraction ducting spigot (A)
5.
1 fixing kit consisting of:
•
3 wall brackets (1,2,3)
•
Rawlplugs and screws
