11. How to cancel a programme
during its cycle
To cancel a programme that is being carried out,
first pause the washing machine by pressing the
START/PAUSE button, then press the RESET button
repeatedly, until the phase indicator lights go out.
12. How to open the door during
a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following
conditions exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the DOOR LOCKED light goes
out and the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the ON/OFF
button again, the washing machine will resume the
programme from the point where it had been
interrupted.
13. End of programme
At the end of the programme, the washing machine
stops automatically and gives an audible signal.
If you had selected the RINSE HOLD option, the
light of the START/PAUSE button flashes and the
phase indicator light
remains lit to indicate that
the water must be drained.
To drain only, depress SKIP/RESET button
once
(the drain light
will illuminate) and then depress
START/PAUSE.
To drain and spin, depress START/PAUSE or select
the spin speed by means of button
and then
depress START/PAUSE.
When the programme has been completed the
audible signal is given.
The DOOR LOCKED light goes out at once.
Press the SKIP/RESET button repeatedly to
erase the programme that has just been carried
out. If you omit to do this, the next time you
switch the washing machine on, you will hear the
audible signal.
Note
: when you switch the machine on, if you must
erase the previously performed programme, it is
also sufficient to press the FABRIC button and
select a new programme.
Press the ON/OFF button to switch the machine off.
The relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking)
or bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
16
132992210.qxd 4/7/03 10:29 AM Pagina 16 (Nero/Process Black pellicola)
