Zanussi FE 1024 N, User Manual

ENGLISH

ENGLISH

19

• Remove any objects from the pump impeller by

rotating it.

• Put the cap back on the emergency emptying

hose and place the latter back in its seat.

• Screw the pump cover fully in.

• Close the pump door.

Water inlet filter

If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose is not
blocked.

Turn off the water tap.
Unscrew the hose from the tap.
Clean the filter with a stiff brush.
Screw the hose back onto the tap.

Emergency emptying out

If the water is not discharged, proceed as follows to
empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• open the pump door;
• place a bowl on the floor and place the end of the

emergency emptying hose into the bowl. Remove
its cap. The water should drain by gravity into the
bowl. Whe the bowl is full, put the cap back on the
hose. Empty the bowl. Repeat the procedure until
water stops flowing out;

• clean the pump if necessary as previously

described;

• replace the emergency emptying hose in its seat

after having plugged it;

• screw the pump cover again and close the door.

P1090

P1117

Frost precautions

If the machine is installed in a place where the
temperature could drop below 0°C, proceed as
follows:

• Remove the plug from the socket.
• Close the water tap and unscrew the water inlet

hose from the tap.

• Place the end of the emergency emptying hose

and that of the inlet hose in a bowl placed on the
floor and let water drain out.

• Screw the water inlet hose back on and reposition

the emergency emptying hose after having put the
cap on again.

By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.
When you use the machine again, make sure that
the ambient temperature is above 0°C.

Important!

Every time you drain the water through the
emergency emptying hose you must pour 2 litres of
water into the main wash compartment of the
detergent drawer and then run the drain
programme 

.To do this :

• depress the ON/OFF button 

to switch the

machine on;

• select a programme by means of button 

;

• depress RESET button 

three times

;

• depress START/PAUSE button 

.

This will activate the ECO valve avoiding that part of
the detergent remains unused at next washing.

132992210.qxd  4/7/03  10:29 AM  Pagina  19    (Nero/Process Black pellicola)