ENGLISH
You have just purchased an electric fryer "with a cold zone". Since the
temperature under the heating element does not exceed 80° in normal use,
frying waste falls into the cold zone and does not flow back into the frying bowl
when it is used later on.
PUTTING INTO SERVICE
The fitted top is fixed into the work surface. The protective blue plastic must
next be carefully removed. It is then ready to receive in order:
1. the oil bowl;
2. the heating element which you swivel downwards on its hinge to position it in
the bowl (Fig. 2);
3. the basket.
This electric fryer absorbs 2,200 watts. It is therefore absolutely necessary for
your electric wiring system to be able to supply that power without danger.
10-amp fuses are necessary.
The fryer must be
compulsorily
connected to an earth.
A two-pole, cutting-off device must be provided of which the contact opening is
greater than 3 mm.
I
The plug must be accessible after installation.
If the supply lead is damaged, it must be replaced by an equivalent lead
(H05RNF 3x1mm²) available from the after-sales department.
It is imperative to raise the glass cover when the electricity supply to the
apparatus is on, in order to avoid an oven effect.
Please do not put hot pans on the cover.
Please let the apparatus to become cold before closing.
This cover is only a decorative element.
IT IS ABSOLUTELY IMPERATIVE THAT A SPACE OF AT LEAST 5 CM BE
LEFT BETWEEN THE BOTTOM OF THE FRYER AND THE FIRST SHELF
OF THE CUPBOARD.
