19
Something not working
If the appliance doesn't work properly check the following
points before asking for service:
The flow of gas seems abnormal
Make sure that:
the flame speader holes are not obstructed;
the pressure regulator is working;
the bottle valve is completely open.
Gas smell in the room
Make sure that:
the gas valve is not open;
the gas supply tube is well positioned and in good
condition; remember to replace it at least once a
year.
The oven doesn't heat
Make sure that the oven knobs are in the correct
worrking positions.
Cooking time is too long
Check that the temperature is correct for the type of
food to be cooked.
The cooker produces smoke
We advise you to clean the oven after use. Splashes
of fat can occur during the cooking of meat and, if
the oven isn't cleaned properly, these produce smoke
and bad smell. (see paragraph concerning cleaning).
The oven lamp doesn't work
The lamp has burnt out. To replace it follow the
instructions given in the relative paragraph.
If, after following all the above checks the appliance still
doesn't work, call your nearest Service Centre givin them
all the necessary information, such as model and serial
number of the appliance.
Never look for an escape of gas with a match;
use instead soap and water.
Maintenance - Technical assistance
Original spare parts
This machine, before leaving the factory, has been
tested and studied by many experts and specialists, in
order to give you the best results.
Any repair work which needs to be carried out should
be done with the utmost care and attention.
For this reason we reccomend that for any problem you
contact the dealer who sold it to you, or our nearest
authorized Service Centre, specifying the nature of the
problem and the particular model which you own.
The gas cocks must be periodically lubricated to ensure
good working and safety.
Maintenance should be performed as follows:
Remove the knob and panel after having taken out
fastening screws.
Loosen the two screws located at the sides of the
cock bar.
Remove the cone and clean it carefully.
Then, apply a thin layer of grease non soluble in
water, suitable for gas cocks. Take care not to
obstruct the gas flow holes by an excess of grease.
Reassemble the whole with utmost care performing the
operations described above inversely.
The guarantee
Your new cooker is covered by guarantee.
You will find the guarantee certificate enclosed. If you
are missing anything, contact your retailer, giving the
date of purchase, model, and the registration number
which is printed on the identification plate.
We ask you to bear in mind that for the guarantee to be
operated, it is necessary to fill in and send the larger part
of the guarantee to
Zanussi
Technical Assistance &
Service within 8 days of purchase, so that we can provide
registration.
We advise you that the smaller part of the certificate, as
well as your receipt and proof of purchase, should be
shown when required to personnel of
Zanussi
Technical
Assistance & Service.
Without following this procedure, the repair personnel will
have to charge you more for the repair.