1. Check the filters
Ensure they are clean and properly positioned (see
"Maintenance and cleaning").
2. Check that there is rinse aid and salt
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
4. Ensure that the spray arms can
rotate freely
5. Measure out detergent
Add the required amount of detergent into the dispenser.
Close the detergent dispenser lid.
6. Close the dishwasher door
7. Setting and starting the programme
Press the On/Off push button: the On/Off and the
“65° NORMAL” indicator light will illuminate.
After 6 seconds from the pressure of the On/Off push
button.the “65° NORMAL” programme starts
automatically.
In this time it is possible to change programme simply
pressing the push button of another programme: the
start of the programme will occur after 6 seconds from
the last pressure of a push button.
It is possible to interrupt the programme by:
●
opening the door
●
pressing the On/Off push button (in this case all the
indicator lights turn off).
Close the door again or press the On/Off, the
programme will start from the point in which it was
interrupted.
9. To cancel a programme in progress
A programme in progress can be cancelled at any time.
Press for 3 seconds the push button of the running
programme untill the indicator light is off.
Only the On/Off indicator light will remain on once the
programme has been cancelled.
It is now possible to select a new washing programme.
10. At the end of the washing programme
The dishwasher will automatically stop and the indicator
light of the programme turns off.
Press the On/Off push button and open the door.
Wait a few minutes before removing the dishes; in this
way they will be cooler and the drying will be improved.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Important!
In general it is not advisable to open the door while the
machine is working; if the door is opened however, a
safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot
phase or immediately after a programme has finished, as
steam may escape.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
10
Operating sequence
