ENGLISH
•
Duration of washing programme
in hours
and minutes, after you have selected a
programme.
While the programme is running (after you have
pressed the START/PAUSE button), the displayed
time value decreases by one unit every minute.
•
Drying time:
the selected drying time is displayed
in minutes or hours and minutes.
After starting the programme, the remaining time is
updated every minute.
•
The machine has stopped with water in the tub
,
at the end of a programme with the RINSE HOLD
(AGUA EN LA CUBA) option: this is indicated by a
static zero
.
•
The machine has completed the programme
:
this is indicated by a
blinking zero
. At the same
time, the door locked light goes out. The zero will
reappear when you switch the machine on, unless
the previous programme has been erased by
means of the RESET (ANUL.) button.
Important!
The first time you use the machine
, when you
switch it on, it may display a blinking zero and give an
audible warning signal. This is due to the fact that the
machine has performed a washing cycle during the
manufacturer’s inspection tests, and this cycle has not
been erased after its completion.
0
1.25
2.05
•
Delay start (Arranque retardado)
, a time value
indicated in hours and selected by means of the
relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of the selected programme
by up to 24 hours in one hour intervals.
•
An incorrect option selection has been made
:
this is indicated by the message
Err
when a
function incompatible with the current programme
is selected.
The incorrect selection is also indicated by an
audible warning signal.
•
An alarm code
indicates a fault in the machine
operation (see the relevant chapter on page 54).
E20
39
