Zanussi WJS 1197 W, Instruction Booklet

26

P0233

2

1

P0255

P0234

P0020

P0256

Unpacking

All transit bolts and packing must be removed

before using the appliance.

You are advised to keep all the packaging for re-use in
case the machine is to be transported again.

Using a spanner unscrew and remove the rear right bolt.
Lay the machine gently on its back, making sure that the
hoses are not squashed.

Remove the polystyrene block from the bottom of the
machine.
Carefully slide out the right polythene bag (1).

Repeat the operation for the left polythene bag (2).

Remove the polystyrene base.
Set the machine upright and remove the two remaining
bolts from the back.
Pull out the three plastic spacers from the holes into
which the bolts were fitted.
Plug the open holes with the plugs which you can find
in the envelope containing the instruction booklet.

Positioning

Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not
impeded by carpets, rugs etc. Check that the machine
does not touch the wall or other kitchen units.
Never place cardboard, wood or similar materials under
the machine to compensate for any unevenness in the
floor.

Your new machine has been designed to be permanently
plumbed in to your home’s water supply and drainage
system. However, if this is not possible, it may be
connected to suitable existing taps with the drain hose
discharging into a sink.

The appliance has two inlet hoses, hot and cold, with
female 3/4” BSP thread connectors. If this connection is
not compatible with the plumbing of the existing
installation, a variety of connectors are available from
good hardware stores and plumbers merchants to suit
most domestic plumbing. Any alteration to your existing
plumbing must be carried out by a competent person, or
qualified plumber.