4
DESCRIPTION OF THE APPLIANCE
ventilation must be as shown in the relevant
paragraph.
Attention: keep ventilation openings clear of
obstruction.
■
If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
■
Placing frozen goods on the top of the appliance
can lead to the accumulation of condensation in
the cavity of the storage tray through contact with
the cold. Electronic components are housed within
this cavity. If condensation should drip onto these
components, the appliance could be damaged by
a short circuit. For this reason do not place frozen
goods on top of the appliance.
■
There are working parts in this product which heat
up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
■
Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
■
If the appliance has been transported horizontally,
it is possible that the oil contained in the
compressor flows in the refrigerant circuit. It is
advisable to wait at least two hours before
connecting the appliance to allow the oil to flow
back in the compressor.
Environment Protection
■
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from your
municipal authorities.
■
The materials used on this appliance marked
with the symbol
are recyclable.
1
2
3
4
5
6
-16
-18
-20
-22
-24
°
C
➀
➂
➁
➁
➁
➀
Freezer controls
➁
Comparments for storing frozen food
➂
Compartment for freezing fresh food
