63
Reversing the doors
Before any operation always remove the plug from
the socket.
Before reversing the door make sure that the
following tools are available:
1 cross-slotted screwdriver
1 slotted screwdriver
1 10 mm wrench
The accessory bag containing:
door fastener
In order to reverse the door proceed as follows:
1. Remove the aeration grid (D) snapped into the
door;
2. Remove the hole caps (G) and the lower hinge
(E) by removing the three screws fastening them;
3. Remove the lower door by sliding it out of the
middle hinge (I). Remove the hole cap for the
hinge pin and mount it on the other side;
4. Remove the lower middle hinge (I), remove the
pin and mount it on the other side;
5. Remove the screw hole cover caps (L) on the
plate on the other side and mount them where
the hinge has just been removed;
6. Mount the hinge on the other side;
7. Mount the lower door;
8. Remove the pin of the lower hinge and mount it
on the other side;
9. Mount the lower hinge (E) on the other side,
insert the hole cap (G), remove hole cap (F) from
the aeration grid (D) by pressing it in the direction
indicated by the arrow and mount it on the other
side;
10.Mount the aeration grid (D) again by snapping it
into place;
11. Remove the three screws of the upper middle
hinge (M);
12.Remove the upper door by sliding it off the upper
pin (A); remove the door hole cap for the hinge
pin and mount it on the other side:
13.Unscrew the upper pin (A) and mount it on the
other side;
14.Remove the three caps (N) inserted in the late for
the hinge screws and mount them on the
opposite side;
15.Remove the washer (P) from the upper middle
hinge, remove the pin and mount it on the other
side by fitting the washer on the pin and
positioning the whole group on the other side;
16.Remove the door fastener (Q) on the upper door.
F
D
PR18
F
F
F
E
E
G
D736
A
3P005
Q
3P004
N
O
P
M
L
I
