2
Cleaning the textile dustbag (23, 24, 25)
1
Open the cleaner cover.
2 Remove the textile bag from the holder.
3
Slide the plastic clip away from the bag to open and
empty.
4
Replace the plastic clip ensuring that both sides of
the bag are parallel.
5
Replace the bag into the holder.
Note: The bag may be washed in luke warm water
and dried completely.
It should not be washed in washing machine.
6
Close the cover by pressing down until it clicks.
Replacing the motor filter
Should be done with every 5th replacement of the dust bag
1.
Open the lid.
2.
Remove the old filter (26.).
3.
Insert a new filter and close the lid.
Replacement of the micro filter and the non
-
w
ashable HEPA filter *
The filter must always be replaced with new ones and
cannot be washed.
Should be done with every 5th
replacement of the dust bag
1.
Open and remove the lid (27. ; 28.).
2.
Remove the filter and replace it with a new one as
shown in the picture (29. ; 31.).
Important: snap on the lower part of the filter frame first
then after the upper one. Make sure the sealing is in place.
Cleaning the washable HEPA filter*
Should be done with every 5th replacement of the dust bag
1.
Open and remove the lid, then remove the filter
(27. ; 28.).
2.
Rinse the inside (dirty side) of the filter in warm tap
water. (30.) Tap the filter frame to remove excess
water. Repeat four times and allow the filter to dry.
Note: Do not use cleaning agents and avoid
touching the delicate filter surface.
3
Replace the filter and lid as shown (29. ; 31.).
Important: snap on the lower part of the filter frame first
then after the upper one. Make sure the sealing is in place.
Cleaning the hose and nozzle
The vacuum cleaner stops automatically if the nozzle, tube,
hose or filters and dust bag becomes blocked.
In such
cases, disconnect from wall socket and allow to cool for 20-
30 minutes. Clear blockage and/or replace filters and dust
bag and restart.
Cleaning tubes and hose
(32.)
Use a cleaning strip or similar to clear the tubes and
hose.
(33.)
It may also be possible to remove the obstruction in
the hose by squeezing it. However, be careful in
case the obstruction is caused by glass or needles
caught inside the hose.
Note: The warranty does not cover any damage to the hose
caused by cleaning it.
Cleaning the floor nozzle
(34.)
To avoid deterioration of suction power, frequently
clean the carpet/hard floor nozzle. The easiest way
to clean it is by using the hose handle.
Cleaning the turbo nozzle (certain models only)
(35.)
Disconnect the nozzle from the vacuum cleaner tube
and remove entangled threads, etc. by snipping
them away with scissors. Use the hose handle to
clean the nozzle.
(36.)
In case the turbo nozzle stops working, open the
cleaning lid and remove any objects that obstructs
the turbine to rotate freely.
(37.)
Disconnect the nozzle from the vacuum cleaner tube
and remove entangled threads, etc. by snipping
them away with scissors. Use the hose handle to
clean the nozzle.
Troubleshooting
The vacuum cleaner does not start
1
Check that the cable is connected to the mains.
2
Check that the plug and cable are not damaged.
3
Check for a blown fuse.
The vacuum cleaner stops
1
Check whether the dust bag is full. If so, replace it
with a new one.
2
Is the nozzle, tube or hose blocked?
3
Are the filters blocked?
Water has entered the vacuum cleaner
It will be necessary to replace the motor at an authorised
Electrolux service centre. Damage to the motor caused by
the penetration of water is not covered by the warranty.
Consumer information
Electrolux decline all responsibility for all damages arising
from any improper use of the appliance or in cases of
tampering with the appliance.
This product is designed with the environment in mind. All
plastic parts are marked for recycling purposes. For details
see our web site: www.electrolux.com
Dustbags and accessories!
If you are experiencing difficulties in finding the right
dustbag, filter or accessories to your new vacuum cleaner -
please call our callcentre (you will find the number in the
warranty folder) or visit our webshop at www.menaulx.com
This appliance conforms with the following EC Directives:
•
Low Voltage Directive 2006/95/EC
•
EMC Directive 89/336/EEC with amendments
92/31/EEC and 93/68/EEC
* Depending on the model
