Zanussi ZBA7190A, User Manual

or damaged power plug may overheat and cause

a fire.

3. Make sure that you can come to the mains plug of

the appliance.

4. Do not pull the mains cable.
5. If the power plug socket is loose, do not insert the

power plug. There is a risk of electric shock or fire.

6. You must not operate the appliance without the

lamp cover

1)

 of interior lighting.

• This appliance is heavy. Care should be taken when

moving it.

• Do not remove nor touch items from the freezer com-

partment if your hands are damp/wet, as this could

cause skin abrasions or frost/freezer burns.

• Avoid prolonged exposure of the appliance to direct

sunlight.

Daily use

• Do not put hot pot on the plastic parts in the appliance.
• Do not store flammable gas and liquid in the appliance,

because they may explode.

• Appliance's manufacturers storage recommendations

should be strictly adhered to. Refer to relevant instruc-

tions.

Care and cleaning

• Before maintenance, switch off the appliance and dis-

connect the mains plug from the mains socket.

• Do not clean the appliance with metal objects.
• Regularly examine the drain in the refrigerator for de-

frosted water. If necessary, clean the drain. If the drain

is blocked, water will collect in the bottom of the ap-

pliance.

Installation

Important!  For electrical connection carefully follow the

instructions given in specific paragraphs.
• Unpack the appliance and check if there are damages

on it. Do not connect the appliance if it is damaged.

Report possible damages immediately to the place you

bought it. In that case retain packing.

• It is advisable to wait at least four hours before con-

necting the appliance to allow the oil to flow back in

the compressor.

• Adequate air circulation should be around the appli-

ance, lacking this leads to overheating. To achieve

sufficient ventilation follow the instructions relevant to

installation.

• Wherever possible the back of the product should be

against a wall to avoid touching or catching warm parts

(compressor, condenser) to prevent possible burn.

• The appliance must not be located close to radiators

or cookers.

• Make sure that the mains plug is accessible after the

installation of the appliance.

• Connect to potable water supply only.

2)

Service

• Any electrical work required to do the servicing of the

appliance should be carried out by a qualified electri-

cian or competent person.

• This product must be serviced by an authorized Service

Centre, and only genuine spare parts must be used.

Environment Protection

This appliance does not contain gasses which could

damage the ozone layer, in either its refrigerant cir-

cuit or insulation materials. The appliance shall not be

discarded together with the urban refuse and rubbish. The

insulation foam contains flammable gases: the appliance

shall be disposed according to the applicable regulations

to obtain from your local authorities. Avoid damaging the

cooling unit, especially at the rear near the heat exchang-

er. The materials used on this appliance marked by the
symbol   are recyclable.

Operation

Switching on

Insert the plug into the wall socket.

Turn the Temperature regulator clockwise to a medium

setting.

1) If the lamp cover is foreseen

2) If a water connection is foreseen

3