Zanussi ZBA7190A, User Manual

Switching off

To turn off the appliance, turn the Temperature regulator

to the "O" position.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings

to obtain the minimum coldness.

• turn the Temperature regulator toward higher settings

to obtain the maximum coldness.

A medium setting is generally the most suitable.

However, the exact setting should be chosen keeping in

mind that the temperature inside the appliance depends

on:

• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important!  If the ambient temperature is high or the

appliance is fully loaded, and the appliance is set to the

lowest temperatures, it may run continuously causing

frost to form on the rear wall. In this case the dial must be

set to a higher temperature to allow automatic defrosting

and therefore reduced energy consumption.

First use

Cleaning the interior

Before using the appliance for the first time, wash the

interior and all internal accessories with lukewarm water

and some neutral soap so as to remove the typical smell

of a brand-new product, then dry thoroughly.

Important!  Do not use detergents or abrasive powders,

as these will damage the finish.

Daily use

Movable shelves

The walls of the refrigera-

tor are equipped with a

series of runners so that

the shelves can be posi-

tioned as desired.

Positioning the door shelves

To permit storage of food

packages of various sizes,

the door shelves can be

placed at different heights.

Gradually pull the shelf in

the direction of the arrows

until it comes free, then

reposition as required.

Helpful hints and tips

Hints for energy saving

• Do not open the door frequently or leave it open longer

than absolutely necessary.

• If the ambient temperature is high and the Temperature

Regulator is set to low temperature and the appliance

is fully loaded, the compressor may run continuously,

causing frost or ice on the evaporator. If this happens,

4