Zanussi ZBA7190A, User Manual

• remove all food
• defrost 

3)

and clean the appliance and all accessories

• leave the door/doors ajar to prevent unpleasant smells.

If the cabinet will be kept on, ask somebody to check it

once in a while to prevent the food inside from spoiling

in case of a power failure.

What to do if…

Warning!  Before troubleshooting, disconnect the

mains plug from the mains socket.

Only a qualified electrician or competent person must do

the troubleshooting that is not in this manual.

Important!  There are some sounds during normal use

(compressor, refrigerant circulation).

Problem

Possible cause

Solution

The appliance does not operate.

The lamp does not operate.

The appliance is switched off.

Switch on the appliance.

The mains plug is not connected to the

mains socket correctly.

Connect the mains plug to the mains

socket correctly.

The appliance has no power. There is

no voltage in the mains socket.

Connect a different electrical appliance

to the mains socket.

Contact a qualified electrician.

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the lamp".

The compressor operates con-

tinually.

The temperature is not set correctly.

Set a higher temperature.

The door is not closed correctly.

Refer to "Closing the door".

The door has been opened too fre-

quently.

Do not keep the door open longer than

necessary.

The product temperature is too high. Let the product temperature decrease to

room temperature before storage.

The room temperature is too high.

Decrease the room temperature.

Water flows on the rear plate of

the refrigerator.

During the automatic defrosting proc-

ess, frost defrosts on the rear plate.

This is correct.

Water flows into the refrigerator. The water outlet is clogged.

Clean the water outlet.

Products prevent that water flows into

the water collector.

Make sure that products do not touch

the rear plate.

Water flows on the ground.

The melting water outlet does not flow

in the evaporative tray above the com-

pressor.

Attach the melting water outlet to the

evaporative tray.

The temperature in the appliance

is too low.

The temperature regulator is not set

correctly.

Set a higher temperature.

The temperature in the appliance

is too high.

The temperature regulator is not set

correctly.

Set a lower temperature.

3) If foreseen.

6