Zanussi ZBB24431SV, User Manual

Problem

Possible cause

Solution

Food products placed in the

appliance were too warm.

Allow food products to cool to

room temperature before stor-

ing.

The door is not closed correct-

ly.

Refer to "Closing the door".

There is too much frost and

ice.

The door is not closed correct-

ly or the gasket is deformed/

dirty.

Refer to "Closing the door".

The water drainage plug is not

correctly positioned.

Position the water drainage

plug in the correct way.

Food products are not wrap-

ped properly.

Wrap the food products better.

Temperature is set incorrectly.

Refer to "Operation" chapter.

Water flows on the rear plate

of the refrigerator.

During the automatic defrost-

ing process, frost melts on the

rear plate.

This is correct.

Water flows into the refrigera-

tor.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that

water flows into the water col-

lector.

Make sure that food products

do not touch the rear plate.

Water flows on the floor.

The melting water outlet is not

connected to the evaporative

tray above the compressor.

Attach the melting water outlet

to the evaporative tray.

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower tempera-

ture.

The door is not closed correct-

ly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened of-

ten.

Open the door only if necessa-

ry.

There is no cold air circulation

in the appliance.

Make sure that there is cold air

circulation in the appliance.

9