Zanussi ZBF22451SV, User Manual

Problem

Possible cause

Solution

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The food products' tempera-

ture is too high.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

The door has been opened

often.

Open the door only if necessary.

The "QuickFreeze function"

is switched on.

Refer to "QuickFreeze function".

There is no cold air circula-

tion in the appliance.

Make sure that there is cold air

circulation in the appliance.

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

CLOSING THE DOOR
1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to assembly

instructions.

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

INSTALLATION

LOCATION

Refer to the assembly instructions for

the installation.

To ensure best performance, install the appliance

well away from sources of heat such as radiators,

boilers, direct sunlight etc. Make sure that air can

circulate freely around the back of the cabinet.

POSITIONING
Install the appliance in a dry, well ventilated indoors

where the ambient temperature corresponds to the

climate class indicated on the rating plate of the

appliance.

Climate

class

Ambient temperature

SN

+10°C to + 32°C

N

+16°C to + 32°C

ST

+16°C to + 38°C

T

+16°C to + 43°C

Some functional problems might occur

for some types of models when

operating outside of that range. The

correct operation can only be

guaranteed within the specified

temperature range. If you have any

doubts regarding where to install the

appliance, please turn to the vendor,

to our customer service or to the

nearest Authorised Service Centre.

ELECTRICAL CONNECTION

CAUTION! Any electrical work

required to install this appliance

should be carried out by a qualified

electrician or competent person.

WARNING! This appliance must be

earthed.

The manufacturer declines any liability

should these safety measures not be

observed.

The wires in the mains lead are coloured in

accordance with the following code:

10