Zanussi ZBHC8, User Manual And Installation Instruction

Delay 

Vent Function

15 minutes

TURBO

-07-

 Installation of Exhaust Pipe

 Electrical engineering-wiring

Please avoid the following situations when installing the exhaust pipe.
1. Over bending.

2. Bending too much.

3. The bend of the pipe comes too close to the main body.

4. The pipe shrinks.

1. Installation and wiring must be done by qualified electrical engineering contractor.

2. Please use the product under rated voltage and rated frequency in accordance with its 

    rating label.

3. Please prepare the unique air switch for this product in the user’s house, and let the air 

    switch should be consistent with air switch off contact all extremely disconnected 

    requirements of distance is greater than 3mm, in order to cut off the power of the product 

    immediately in case of accident.

4. Must be connected to the ground wire.

5. During installation, the fixed power wiring must be in accordance with local safety 

    regulations.

6. For metal net bottom, steel wire net bottom of walls or wooden houses with the metal 

    surface, etc. when install metal exhaust pipe through, do paying attention that there shall be 

    no electrical contact.

7. When the power supply is insufficient, contact with electric power supply company.

8.Prior to the opening front cover, please make sure that the machine is powered off.

9. This product shall not be placed directly below the power outlet, do not install too close to 

    the socket to prevent the host electrical equipment from being damaged and damage other 

    electrical appliances.

Over bending

Bending too much

The bend of the

pipe comes too

close to the main

body

The pipe shrunks

ION

OSC

TIMER

FAN

ON/OFF

MODE

AUTO

CIR

DRY COOL

VENT

HEAT

DRY HOT

Infrared Wireless 

Remote Control