Replacing the lamp
Caution!
Disconnect the plug from the
mains socket.
Remove the screw
from the lamp cover.
Remove the lamp
cover (refer to the il-
lustration).
Replace the used
lamp with a new lamp
of the same power
and specifically de-
signed for household
appliances (the maxi-
mum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to
the lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "In-
stallation".
3.
If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension of the recess
Height
1225 mm
Width
560 mm
Depth
550 mm
Rising Time
20 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution!
Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
22
www.zanussi.com
Summary of Contents for ZBT20420SA
Page 53: ...53 www zanussi com ...
Page 54: ...54 www zanussi com ...
Page 55: ...55 www zanussi com ...