x
x
1
If necessary cut
the adhesive sealing
strip and then apply it
to the appliance as
shown in figure.
1
2
2
Install the appli-
ance in the niche.
Push the appliance in
the direction of the
arrows (1) until the
upper gap cover
stops against the
kitchen furniture.
Push the appliance in
the direction of the
arrows (2) against the
cupboard on the op-
posite side of the
hinge.
44mm
4mm
3
Adjust the appli-
ance in the niche.
Make sure that the
distance between the
appliance and the
cupboard front-edge
is 44 mm.
Make sure that the
clearance between
the appliance and the
cupboard is 4 mm.
Open the door. Put
the lower hinge cover
in position.
I
I
4
Attach the appli-
ance to the niche
with 4 screws.
5
Remove the cor-
rect part from the
hinge cover (E). Make
sure to remove the
part DX, in the case
of right hinge, SX in
opposite case.
E
E
D
C
B
6
Attach the covers
(C, D) to the lugs and
the hinge holes.
Install the vent grille
(B).
Attach the hinge cov-
ers (E) to the hinge.
Ha
Hb
Hd
Hc
7
Disconnect the
parts (Ha), (Hb), (Hc)
and (Hd).
21 mm
21 mm
~50 mm
~50 mm
90
o
90
o
8
Install the part
(Ha) on the inner side
of the kitchen furni-
ture.
Ha
Hc
9
Push the part (Hc)
on the part (Ha).
Hb
Ha
8 mm
10
Open the appli-
ance door and the
kitchen furniture door
at an angle of 90°.
Insert the small
square (Hb) into
guide (Ha).
Put together the ap-
pliance door and the
furniture door and
mark the holes.
24
www.zanussi.com
Summary of Contents for ZBT20420SA
Page 53: ...53 www zanussi com ...
Page 54: ...54 www zanussi com ...
Page 55: ...55 www zanussi com ...