5
Remove the correct
part from the hinge cover
(E). Make sure to remove
the part DX, in the case of
right hinge, SX in opposite
case.
E
E
D
C
B
6
Attach the covers (C,
D) to the lugs and the
hinge holes.
Install the vent grille (B).
Attach the hinge covers (E)
to the hinge.
Ha
Hb
Hd
Hc
7
Disconnect the parts
(Ha), (Hb), (Hc) and (Hd).
21 mm
21 mm
~50 mm
~50 mm
90
o
90
o
8
Install the part (Ha) on
the inner side of the kitch-
en furniture.
Ha
Hc
9
Push the part (Hc) on
the part (Ha).
Hb
Ha
8 mm
10
Open the appliance
door and the kitchen furni-
ture door at an angle of
90°.
Insert the small square
(Hb) into guide (Ha).
Put together the appliance
door and the furniture
door and mark the holes.
Ha
8 mm
K
11
Remove the brackets
and mark a distance of 8
mm from the outer edge of
the door where the nail
must be fitted (K).
Hb
12
Place the small square
on the guide again and fix
it with the screws sup-
plied.
Align the kitchen furniture
door and the appliance
door by adjusting the part
Hb.
Hb
Hd
13
Press the part (Hd) on
the part (Hb).
Do a final check to make sure that:
• All screws are tightened.
• The magnetic sealing strip is attached tightly to the
cabinet.
Important! If the ambient temperature is low (for example,
in the Winter), the size of the gasket decreases. The size of
the gasket increases when the ambient temperature
increases.
22
Summary of Contents for ZBT23420SA
Page 47: ...47 ...
