17
Door reversal
Unplug the appliance before all operations.
To reverse the door, proceed as follows:
1. dismantle the lower hinge (3), pin (1) and the
screw (2);
2. slide the door out from pin (G),unscrew the pin
and reposition on the opposite side;
3. unscrew the left front foot and reposition on the
opposite side;
4. unscrew the two screws which mask the holes for
fixing the hinge from the left front side;
5. reassemble the door;
6. reassemble the lower hinge (turning it 180¡), the
pin and the screw on the opposite side, as shown
in the figure;
7. Unscrew the handle. Refit it on the opposite side
after having pierced the plugs with a punch.
Cover the holes left open with the plugs supplied
in the documentation pack.
Attention
After completion of the door reversibility
operation, verify that the door gasket is adherent
to the cabinet. If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
Fitting the door panel
(for models equipped with door frame)
To fit the door panel, proceed as follows:
¥
remove the fixing screws and remove the frame
side opposite the handle;
¥
loosen, without removing them, all remaining
screws fixing the door frame;
¥
insert the panel from the side on which the frame
has been removed and push it fully in;
¥
refit the frame side and tighten all the screws.
Note
The panel size should be 1-2 mm smaller than the
door; the maximum permissible panel thickness is 4
mm.
G
180
°
1
3
2
D299
2
D162/1
