19
Electrical connection
Important
Any electrical work required to
install this hob should be carried out by
a qualified electrician or competent
person, in accordance with the current
regulations.
THIS COOKER MUST BE EARTHED.
The
manufacturer declines any
liability should these safety measures
not be observed.
Before
switching on, make sure the
electricity supply voltage is the same as that
indicated
on the rating plate.
Fuse capacity:
-
5
A
Note:
The unit is preset to work with a voltage of
single phase 230V.
Before making the connection make sure
that: the energy power available in the
user’s house is sufficient for the normal
supply of this appliance (see rating plate).
The unit is correctly connected to earth
through a suitable plug and according to the
installation country Laws.
The socket or the omnipolar switch used for
the connection must be easily reached with
the installed appliance. The appliance is
supplied with electric cord.
If you wish to directly connect to the mains,
you have to interpose an omnipolar switch
with a minimum opening between contacts
of 3 mm, between the unit and the mains,
complying with the existing regulations. The
brown (or red) live wire (originating from the
clamp of the cooker junction box) must
always be connected to the phase of the
mains supply.
The switch should be sited within 2m of the
hob and be easily accessible upon
completion of the installation.
The yellow-green grounding cable has not
to be interrupted by the switch.
connection of
flexible hose
clamp
YES
power
cord
fig. 16
connection of
flexible hose
clamp
NO
power
cord
fig. 17
.
