5
Door reversibility
(Fig. 3)
Unplug the refrigerator from the wall socket before
performing the following operations:
Remove socle (2) by unscrewing its front screws.
Slide it downwards to release it from the central
runners.
Remove bottom hinge (1).
Unscrew pin (C) from hole (A) and screw it into hole
(B).
Remove door stop hinge (D) and refit it on the
opposite side.
Slide out the lower door from middle hinge.
Remove middle hinge (4) and upper hinge (3) and
refit them on the opposite side.
Refit lower door and bottom hinge (1) on the
opposite side.
Turn the base upside-down and refit it.
Remove handles (5-6) and refit them on the opposite
side.
The holes that are not used are to be masked with
the plastic plugs removed.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of
the gasket or accelerate this process by heating up
the part involved with a normal hairdrier.
Fig. 3
D158
5
6
3
4
D
C
A
1
B
2
