19
Zanussi 818 14 55-02/6
Before installing the cabinet
Affix the supplied plastic peaces at the rear of the
cabinet.
Cleaning
Wash the inside of the cabinet using lukewarm
water, a mild washing-up detergent and a soft cloth.
Mounting of door panels
The door can be decorated with panels. If youcabinet
is not equipped with door frames, they can be
orderd seperately.
1. Remove the handel and the frame of the side
where the handle is fitted.
2 Loosen the screws of the other frames.
3 Adjust the panel and screw it in place.
4. Mount the removed frame and the handle.
Measurements fo the door panels:
Height
Width
Depth
1436
1636
584
584
4max
4max
ZC345P-1
ZC395P-1
(mm)
(mm)
(mm)
Remove the transport supports
Remove the tape and the transport supports from
·
the door sides
·
inside the door hinges
·
the shelves
Remove the transport support on the glass shelf by
pushing the support forward along the edge of the
shelf until it stops. Take hold of the rear edge of the
glass shelf and pull the shelf and transport support
forward until the shelf tilts and the transport support
can be removed. Some models are fitted with a
silencing pad under the cabinet. Do not remove this
pad.
Installing the cabinet
To obtain the best performance from the cabinet,
ensure :
·
the cabinet is placed in a dry, cool place and
is not exposed to direct sunlight.
·
the cabinet is not placed close to a source of
heat, e.g. a cooker or dishwasher.
·
the cabinet is level. The cabinet should not lean
against any wall. If necessary adjust the
feet using the adjustment spanner supplied.
·
there is good air circulation around the cabinet
and that the air channels below and behind
the cabinet are not blocked. The ventilation
space above the cabinet must be at least 4 cm.
The ventilation space can either be
a) directly above the cabinet, or
b) behind and above the top cupboard. In this case,
the space behind the cupboard must be at least
50 mm deep.
