10.
Set the temperature to MAX setting and close
the lid. Wait two or three hours before you
reload previously removed food into the
appliance.
11.
Set the temperature to the desired setting.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
WHAT TO DO IF...
There are sounds which may occur during the operation of the appliance (e.g. bubbling,
whirring, cracking or clicking), which are normal.
Problem
Possible cause
Solution
The appliance does not oper-
ate.
The appliance is switched off.
Switch on the appliance.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
Check if the appliance is plug-
ged correctly.
There is no voltage in the
mains socket.
Connect the appliance to a
different electrical mains sock-
et. Contact a qualified electri-
cian.
The appliance is noisy.
The appliance is not supported
properly.
Check if the appliance stands
stable. Refer to "Installation/
Location" chapter.
The appliance touches the wall
or other objects.
Slightly move the appliance.
Refer to "Installation/Location"
chapter.
Temperature indicator flashes
from left to right.
Temperature sensor error.
Contact the Authorised Serv-
ice Center.
The lid does not close com-
pletely.
Food packages are blocking
the lid.
Arrange the packages in the
right way.
There is too much frost in the
appliance.
Defrost the appliance. Refer to
"Care and cleaning/Defrosting
the appliance" chapter.
The lid is difficult to open.
The lid gasket is dirty or sticky.
Clean the lid gasket.
The lamp does not work.
The lamp is defective.
Contact the Authorised Serv-
ice Center to replace the LED
light.
The compressor operates con-
tinually.
Temperature is set incorrectly.
Refer to "Control panel/
Temperature regulation" chap-
ter.
22
Summary of Contents for ZCAN10FW1
Page 63: ...63 ...