PPO
OSSIITTIIO
ON
N
Place the freezer horizontally on a firm surface, resting
on all four plastic feet. Use a wooden block or similar
object to compensate for any bumps/holes in the
surface.
The room should be dry and adequately ventilated.
If the room temperature exceeds 32°C, or falls below
freezing point, the freezer will not function as it should.
Do not place the freezer close to sources of heat,
radiators, chimneys, etc., and do not place the freezer in
direct sunlight.
If the freezer has been handled standing on end it should
be allowed to stand in normal position for about 12 hours
before switching it on.
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
SSW
WIITTC
CH
HIIN
NG
G O
ON
N
Before switching on, the freezer should be cleaned inside.
See under Maintenance.
Set the thermostat button in middle position. Allow the
freezer to run for several hours before placing food inside.
4
INSTALLATION
EELLEEC
CTTR
RIIC
CA
ALL R
REEQ
QU
UIIR
REEM
MEEN
NTTSS
Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating
plate, located inside the lid.
WARNING:
This appliance must be earthed.
