Before first use
Remove all packaging, both inside and outside the
oven, before using the appliance. Do not remove the
rating plate.
Caution! To open the oven door, always hold the
handle in the centre.
Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Caution! Do not use abrasive cleaning agents! This
can damage the surface. Refer to chapter "Care and
Cleaning".
Preheating
Set an oven function and maximum temperature and run
an empty oven for 45 minutes, to burn off any residue
from the cavity surface. Accessories can become hotter
than in normal use. During this period an odour can be
emitted. This is normal. Make sure the room is well ven-
tilated.
Hob - Daily Use
Control knobs
Symbol
Description
no gas supply / off position
maximum gas supply
minimum gas supply
Ignition of the burner
Warning! Be very careful when you use open fire in
kitchen environment. Manufacturer decline any
responsibility in case misuse of the flame
Always light the burner before you put cookware.
To light the burner:
1. Put the flame near the burner.
2. Push the related control knob down for 10 seconds
and turn it counterclockwise to the maximum position
.
3. Keep the control knob pushed for approximately 10
seconds; this will let thermocouple to warm up. If not,
the gas supply will be interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does not light, check
if the crown and its cap are in correct positions.
1
2
3
4
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
Warning! If the burner does not light after 15
seconds, release the control knob, turn it into off
position and try to light the burner again after minimum
1 minute.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
17
Summary of Contents for ZCG054G
Page 51: ...51 ...
