Installation
WARNING!
Refer to Safety chapters.
Technical data
Dimensions
Height
894 - 912 mm
Width
550 mm
Depth
600 mm
Location of the appliance
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
For the distances of fitting check the table.
A
E
C
B
D
F
Distances
Dimension
mm
A
650
B
150
C
20
D
400
E
450
F
less than 400
Levelling of the appliance
Use small feet on the bottom of appliance to set
the appliance top surface level with other
surfaces.
The stability chain
CAUTION!
Install the stability chain to prevent
the appliance from tilting. The
stability chain only works when the
appliance is put in a correct area.
1. Measure down 180 mm from the appliance
top surface, then measure right 30 mm.
2. Mark the position of the wall and this gives
anchor point for the stability chain.
30 mm
180 mm
Other technical data
WARNING!
These instructions are only valid in
the countries whose symbols appear
on this booklet's cover.
Gas category:
I2H
Gas supply:
G20 (2H) 20 mbar
Voltage:
220-240 V
Frequency:
50/60 Hz
20
www.zanussi.com