Zanussi ZCG61281XA, User Manual

5. Release the burner injector D with a 7 mm

socket spanner and replace it with a different

one.

Assemble the burner in a revers sequence.
Replace the gas type sticker near the gas supply

ramp with the one related to the new gas type.

ADJUSTING THE MINIMUM GAS LEVEL ON

THE OVEN BURNER

1. Disconnect the appliance from the electricity.

2. Remove the knob for the oven functions. If

there is no access to the bypass screw

dismount the control panel before adjustment

start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

A

Changing from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

3. Connect the appliance to the electricity.

Changing from liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position A.

2. Put the knob for the oven functions back.

3. Connect the appliance to the electricity. 

WARNING! Put the mains plug

into the mains socket only if all

parts are back into their initial

position. There is a risk of injury.

4. Light the burner.

Refer to "Oven - Daily use" chapter.

5. Turn the knob for the oven functions on the

minimum position.

6. Remove the knob for the oven functions again.

7. Screw on slowly the bypass screw till the flame

becomes minimum and stable.

8. Put the knob for the oven functions back.

9. Set the maximum gas flow position on the knob

for the oven functions and let the oven heat for

at least 10 minutes.

10. Quickly turn the knob for the oven functions

from maximum to the minimum gas flow

position.

Control the flame. Make sure the flame does not go

out when you turn the knob to the minimum gas

flow position. There must be a small regular flame

on the oven burner crown. If the flame goes out

adjust the oven burner again.

GAS GRILL INJECTOR REPLACEMENT

1. Release the screws which keep the grill burner

in position A.

A

2. Release the burner injector with a 7 mm socket

spanner and replace it with a right one.

3. Assemble the burner in a reverse sequence.

Before you fix the screw, make sure that the

burner is pushed correctly to the back panel.

Test the grill injectors.

ELECTRICAL INSTALLATION

WARNING! The manufacturer is not

responsible if you do not follow the

safety precautions from Safety

chapters.

11