14
www.zanussi.com
Fig.8
Oven seal
The oven seal guarantees the correct
functioning of the oven. We recommend you:
• clean it, avoiding abrasive tools or
products.
• check its state now and then.
If the oven door seal has become hard
or is damaged, contact our Service
Centre and avoid using the oven until it
has been repaired.
Fig.9
Oven side-guide rails
To allow for a better cleaning of the side grids,
you can extract them this way:
Push with a finger on the last of the slots to
release the grid from its hold.
1
Lift it towards the top and extract the grid.
To put them back into place, reverse the order
of this operation.
Self-cleaning panels
Oven walls are protected by panels coated
with a grease-proof, microporous enamel that
absorbs and eliminates splattering during
baking.
If there is a lot of liquid or grease, dry
immediately with a damp sponge and heat the
oven for 2 hours on the maximum thermostat
position. Wait for the oven to cool down and
then go over it again with a damp sponge. If
you are unable to remove all the substances,
repeat the above procedure.
It is, however, advisable to periodically remove
the panels and wash them with warm soapy
water and dry them with a soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in the
previous paragraph.
• Remove both side panels
1
(fig.10).
• Remove back panel
4
by unscrewing
respective locking screws
5
(fig.11).
• Repeat previous operations in reverse
order to replace all elements.
Important!
Position both side panels
1
by taking the locking pin
2
out of the
hole
3
(fig. 10).
2
Fig. 11
Fig. 10
