15
www.zanussi.com
Some problems can be caused either as the results of simple maintenance operations or by
incorrect selection of settings. Prior to contacting a Service Centre please check the following
chart.
Problem
Remedy
The appliance is not
working
• Make sure the gas tap is open
• Check the plug is in
• Check that the knobs are set correctly for cooking and then repeat the
operations given in the handbook
• Check the electrical system safety switches (RCD). If there is failure in the
system call an electrician in.
The electric oven is not
working
• Check that the programmer accessory, if there is one, is on the manual
position and then repeat the operations described in the manual
The thermostat is not
working
• Contact Service Centre .
The electric thermostat
warning light does not
switch on during use
• Turn the thermostat round to a hotter temperature
• Turn the selector round to a different function
The oven light does not
switch on
• Make sure the lamp is firmly screwed in place
• Buy a lamp for high temperatures at one of our Service Centre and fit it
following the instructions given “Replacing the oven lamp” paragraph.
What to do if...
Installation
Technical information
Warning! Alwais use safety gloves
while handling the cooker.
• The installation, adjustments, conversions
and maintenance operations listed in this
part must only be carried out by qualified
personnel. The manufacturer cannot
be held responsible for any damage to
persons or property resulting from an
incorrect installation of the appliance.
• The safety and automatic adjustment
devices of the appliances may, during its
life, only be modified by the manufacturer or
duly authorised supplier.
• In accordance with the gas standard, the
all-gas and combi appliances are “class
1” (free standing) or “class 2 subclass 1”
(recessed) and, as such, must comply with
the clearances specified in figure below
consequently any side walls must be no
higher than the work top.
• The walls adjacent to and surrounding the
appliances must be able to withstand an
temperature of 95°C.
• The installation of all-gas and combi
appliances must comply with the standards
in force.
• This appliance is not connected to a flue
for discharge of the combustion products;
therefore, it must be connected in compliance
with the above mentioned installation rules.
