21
www.zanussi.com
Fig. 13
Changing the flexible gas hose
In order to guarantee that the gas hose is
always in excellent condition we strongly
recommend changing it on the date you will
find printed on it.
Replacing the electrical components
• The rear protection will have to be removed
in order to change the electrical heating
elements, spit motor, terminal board and
power cable.
• If you have to change the power cable
(see the cross section on table in
the “Technical information” section),
always keep the earth wire longer
than the phase wires and, in addition,
follow all the instructions given in the
“Electrical connection” paragraph.
• To change the oven lamp see the
instructions given
“Replacing the oven
lamp” paragraph.
• To change the spark generator, the spark
electrodes and the lamp holder the work
top has to be removed as indicated in
paragraph
“Replacing the taps”.
• To change the lamp-holder
force the
tabs of blockage and take the lamp-holder
toward the inside of the oven.
• To change the eventual programming
accessory, the thermostat, commutators,
the switchs and the microswitchs, , remove
the front panel as indicated in paragraph
“Replacing the taps”.
Fig. 14