6
www.zanussi.com
the corresponding push button.
N.B.:
At the end of each setting session
(except for the minute counter) the
programmer turns the oven off. Check when
next using the oven, if the programmer is
not going to be used, that the latter is set on
manual operation (see the instructions given
further on).
Setting the time (from 0.01 to 24.00 =
hh,mm)
After connecting to the electricity mains
or subsequent to a power cut, AUTO and
“0.00” will both flash simultaneously on
the display.Press push buttons 2 and 3
simultaneously and start setting the current
time by pressing push button 5 or 6.
Once set the AUTO symbol will turn off and
the
symbol, for manual operation, will
turn on.
Minute counter (from 0.01 to 0.59 =
hh,mm)
Press push button 1 and select cooking time
with push button 5 or 6. The
symbol
turns on. At the end of the set time the
buzzer will go off and the
symbol turns off.
Semi-automatic operation
(with cooking time from 0.01 to 23.59 =
hh,mm)
By pressing push button 2 and setting the
length of cooking time with push button 5 or
6, the AUTO and symbols will light up and
stay on all the time. At the end of the set time
the
symbol will turn off, the AUTO symbol
will flash and the buzzer will go off.
Semi-automatic operation
(with end of cooking time from 0.01 to
23.59 = hh,mm)
By pressing push button 3 and setting the
end of cooking time with push button 6, the
AUTO and symbols will turn on and stay on
all the time. At the end of the set time the
symbol will turn off, the AUTO symbol will
flash and the buzzer will go off.
Automatic operation
(with the start of cooking time delayed)
First programme cooking time (both the
AUTO and
symbol will turn on) and then
the end of cooking time (the
symbol will
turn off) as described previously. The
symbol will turn on again when baking in the
oven starts. At the end of cooking time the
symbol will turn off, the AUTO symbol will
flash and the buzzer will go off.
Manual operation
Manual operation is only possible when the
automatic programming has finished or after
having cancelled it by pressing push button
4. The AUTO symbol disappears and the
symbol turns on.Manual operation is only
possible when the automatic programming
has finished or after having cancelled it by
pressing push button 4. The AUTO symbol
disappears and the
symbol turns on.
Buzzer
The buzzer will go off at the end of a
programme or at the end of the minute
counter function and lasts about 7 minutes.
The buzzer can be stopped by pressing one
of the function push buttons.Programme
start and control.The programme starts after
setting. The programme set can be controlled
at any time by pressing the corresponding
push button.
Correcting/cancelling the programme
setting
An automatic function programming error
will occur if the time shown on the clock
is between the cooking start time and
cooking end time. This error will be signalled
immediately by a buzzer and the AUTO
symbol will flash. A setting error can be
corrected by altering the duration or end of
cooking time. Any programme that has been
set can be corrected at any time by pressing
the corresponding programming key and then
key 5 or 6. To cancel a programme, correct
the time set bringing it to a value of “0.00”.
If functioning time is cancelled the end of
functioning is cancelled too and vice versa.
The oven turns off automatically and the
AUTO symbol flashes. Press key 4 to set the
programmer on manual operation. The right
time cannot be corrected when the automatic
operation programme is working.
