7
•
Incorrect option selection
If you select an option that is not compatible with
the programme you have selected, the display
shows
Err
(error).
This code will reappear during the execution of the
programme if you press one of the option buttons or
turn the programme selector.
•
Alarm code
In the case of a functional problem, the display
shows an alarm code (e.g.
E21
). See page 13 for
more detailed information.
8 START/PAUSE button
Press this button to start the dryer after having
selected the programme and the options.
The relevant light will stop flashing. If you have
chosen a delayed start, the machine will begin the
countdown.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the
programme from the point at which it was
interrupted.
This button must also be depressed after a power
failure and after having re-inserted the water
reservoir, if it has been emptied in the middle of a
programme after lighting up of the “FULL
TANK” light.
In both cases the light of the Start/Pause button
flashes to remind you that the start button needs to be
pressed again.
E21
Important!
After emptying the water reservoir following a full
tank light, there may be a short delay before the
machine will re-start to allow the system to re set.
9 Indicator Lights
These lights indicate the following functions:
“DRYING” light
This light indicates that the appliance is in the drying
phase.
“COOLING” light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a 10
minute cooling phase to cool the laundry.
“END” light
This light is on at the end of the cooling phase,
during the anti-creasing phase and at the end of the
programme.
“CLEAN FILTERS” light
This light illuminates at the end of the programme to
remind you that the filters must be cleaned.
“FULL TANK” light
This light comes on at the end of the programme to
remind you that the water reservoir must be emptied
out. If this light illuminates during a programme this
means that the water reservoir is full. The buzzer
sounds, the programme stops, the light of the
Start/Pause button flashes.
“CLEAN CONDENSER” light
It comes on every 80 cycles to remind you that the
condenser must be cleaned.
125983910.qxp 2006-05-08 15:00 Page 7
