Zanussi ZDC47100G, User Manual

• The tumble dryer must be installed in a clean place,

where dirt does not build up.

• Air must be able to circulate freely all round the appli-

ance. Do not obstruct the front ventilation grille or the

air intake grilles at the back of the machine.

• To keep vibration and noise to a minimum when the

dryer is in use, it should be placed on a firm, level

surface.

• Once in its permanent operating position, check that

the dryer is absolutely level with the aid of a spirit level.

If it is not, raise or lower the feet until it is.

• The feet must never be removed. Do not restrict the

floor clearance through deep pile carpets, strips of

wood or similar. This might cause heat built-up which

would interfere with the operation of the appliance.

Important! 
The hot air emitted by the tumble dryer can reach tem-

peratures of up to 60°C. The appliance must therefore not

be installed on floors which are not resistant to high tem-

peratures.

When operating the tumble dryer, the room temperature

must not be lower than +5°C and higher than +35°C, as

it may affect the performance of the appliance.
Important!  Should the appliance be moved, it must be

transported vertically.
Important!  The appliance must not be installed behind

the lockable door, a sliding door a door with a hinge on

the opposite side to that of the appliance.

Removing transport safety packaging

Caution!  Before use all parts of the transport

packaging must be removed.

1. Open loading door

2. Pull off adhesive strips

from inside machine on

top of drum.

3. Remove foil hose and polystyrene padding from the

machine.

Electrical connection

Details on mains voltage, type of current and the fuses

required should be taken from the rating plate. The rating

plate is fitted near the loading aperture (see “Product de-

scription” chapter).

Connect the machine to an earthed socket, in accordance

with current wiring regulations.

Warning!  The manufacturer declines any

responsibility for damage or injury through failure

to comply with the above safety precautions.

Should the appliance power supply cable need to be

replaced, this must be carried out by an authorised service

engineer or a qualified electrician. .
The appliance is supplied with a 13 amp plug fitted. In the

event of having to change the fuse in the plug supplied,

a 13 amp ASTA approved BS 1363/A fuse must be used.

1

2

3

4

The wires in the mains lead are coloured in accordance

with the following code:

1

Blue - Neutral

2

cord clamp

3

Brown - Live

13