4
Green and Yellow - Earth
The wire coloured green and yellow must be connected
to the terminal marked with the letter «E» or by the earth
symbol or coloured green and yellow.
The wire coloured blue must be connected to the terminal
«N» or coloured black.
The wire coloured brown must be connected to the ter-
minal marked «L» or coloured red.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure over
the outer sheath.
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely.
Warning! The plug must be accessible after
installing the machine.
Permanent connection
In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap
of 3 mm between the switch contacts and of a type suitable
for the required load in compliance with the current elec-
trical regulations.
The switch must not break the yellow and green earth
cable at any point.
Door reversal
To make it easier to load or unload the laundry, the door
can be reversed.
Warning! The door must only be reversed by an
authorised service engineer.
Please contact your local Service Force Centre. The en-
gineer will carry out the door reversal at your cost.
Special accessories
• Stacking Kit
Available from your Service Force Centre or your
specialist dealer
These intermediate installation kits can be used to ar-
range the dryer and an washing machine (60 cm wide,
front loaded) as a space-saving washer/dryer stack.
The washing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the kit.
• drain kit
Available from your Service Force Centre or your
specialist dealer
Installation kit for direct draining of condensation into
a basin, siphon, gully, etc. The condensation tank then
no longer has to be drained, it must however remain
in its intended position in the machine.
Read carefully the instructions supplied with the kit.
• pedestal with the drawer
Available from your Service Force Centre or your
specialist dealer
To situate the dryer in optimal high and have some
additional space to store (e.g. laundry).
Read carefully the instructions supplied with the kit.
Service
In the event of technical faults, please first check whether
you can remedy the problem yourself with the help of the
operating instructions - see chapter
What to do if….
If you were not able to remedy the problem yourself,
please contact the Customer Care Department or one of
our service partners.
In order to be able to assist you quickly, we require the
following information:
– Model description
– Product number (PNC)
– Serial number (S No. is on rating plate stuck to the
product - to find it see chapter
Product description
))
– Type of fault
– Any error messages displayed by the appliance
So that you have the necessary reference numbers from
your appliance at hand, we recommend that you write
them in here:
Model description:
........................................
PNC:
........................................
S No:
........................................
14
Summary of Contents for ZDC47100G
Page 1: ...EN User manual 2 Tumble Dryer ZDC47100G ...
Page 15: ...15 ...