Zanussi ZDC47100G, User Manual

lights will flash. The drum turns alternately in both direc-

tions during drying.

All drying programmes end with a 10 minute cooling

phase. You may remove the laundry after this phase.

If the door of the appliance or the small door at the bottom

is opened while the programme is running, this button

must be pressed again after closing the door in order to

restart the programme from the point at which it was in-

terrupted. This button must be depressed also after a

power failure and after having reinserted the water reser-

voir, if it has been emptied in the middle of a programme

after lighting up of light Empty Tank  .

In both cases the light of the Start/Pause button flashes

to remind you that the start button needs to be pressed

again.

Indicator lights

These lights indicate the following functions:
• Drying light: This light indicates that the appliance is

in the drying phase.

• Cooling light: This light indicates that the appliance is

in the cooling phase. At the end of drying, there is a

10 minute cooling phase to cool the laundry.

• End/Anticrease light: This light is on at the end of the

cooling phase, during the anticreasing phase and at

the end of the programme.

• Condenser light: It comes on every 80 cycles to remind

you that the condenser must be cleaned.

• Filter light: This light illuminates at the end of the pro-

gramme to remind you that the filters must be cleaned.

• Empty Tank light: This light indicates that the appliance

is in the drying phase. This light comes on at the end

of the programme to remind you that the water reservoir

must be emptied out. If this light illuminates during a

programme this means that the water reservoir is full.

The buzzer sounds, the programme stops, the light of

the Start/Pause button flashes. This light comes on

also when the water reservoir is not inserted correctly.

Changing programme

To change a programme which has been selected by mis-

take once the programme has started, first turn the pro-

gramme selector to  - O OFF position. The programme is

cancelled.

The programme can no longer be changed directly

once the programme has started. If nevertheless

there is an attempt to change the programme on the pro-

gramme knob or if an function button (excluding the
BUZZER button

1)

) is pressed, led on the START/PAUSE

button starts flashing temporarily in red. The drying pro-

gramme is not however affected by this (laundry protec-

tion).

At the end of the programme

If the laundry is not removed at the end of the cycle, the

dryer performs an anticreasing phase (duration: 30 mi-

nutes maximum).

If you do not remove the laundry, the dryer will stop au-

tomatically at the end of the anticreasing phase. Lights

End/Anticrease  ,  Filter and Empty Tank  remain lit and

the buzzer sounds for 2 minutes.

Turn the programme selector dial to “ O ” to switch the

machine off. Remove the laundry from the drum and care-

fully check that the drum is empty.

If you do not intend to carry out another wash, close the

water tap. Leave the door open to prevent the formation

of mildew and unpleasant smells.

If you open and then close the door before turning

the selector dial to “ O ” all the lights corresponding

to the phases making up the performed programme come

on.

After each use

• Clean the filters.
• Empty the water reservoir.

Cleaning and maintenance

Cleaning lint filters

To ensure that the appliance works perfectly, the lint filters

in the door and in front of the drum must be cleaned after

every drying cycle.

Caution!  Important. Never operate the dryer without

the lint filter or with a damaged or blocked lint filter.

1) Only dryers with buzzer button

8