Zanussi ZDC47100G, User Manual

1. Open loading door

2. After a period of time, a

gleam due to detergent

residue on laundry forms

on the filters. To prevent

this clean the filters with

warm water using a brush.

Remove the filter from the

door pulling it out.

3. Use a damp hand to

clean the micro- fine filter,

which is built into the low-

er part of the loading aper-

ture.

4. Remove fluff from lint

filter, preferably using a

damp hand for this pur-

pose.

Replace the filter.

Cleaning heat exchanger

Clean the condenser when light Condenser comes on.

The condenser is situated at the lower part of the cabinet

behind a small door.

1. To open the door, push

the catch as per picture.

During the drying cycle or

at the end, it is normal for

water to be present on the

surface of the condenser

insertion.

2. Turn the two red stops

downwards.

3. Pull out the condenser

unit holding it at the han-

dle .

4. Clean it with a brush and

rinse it under the shower if

necessary. Also clean the

outside, removing all fluff.

Clean the rubber seal

round the condenser cab-

inet and in the inner part of

the small door with a damp

cloth.

Important!  Do not use pointed objects or utensils to clean

the spaces between the plates, as this could damage the

condenser and make it permeable. Re-fit the condenser,

turn the red stops upwards and close the door.
Important!  Do not use this appliance if the condenser has

not been fitted.

Emptying the water reservoir

Water extracted from the laundry condenses inside the

machine and is collected in a reservoir. The reservoir must

be emptied after each drying cycle to ensure efficient op-

eration when the machine is next used. The pilot light

Empty Tank reminds you this operation.

9