7
Defrosting
The freezer compartment will become progressively
covered with frost. This should be removed with the
special plastic scraper provided whenever the
thickness of frost exceeds 1 /4".
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
and it is advisable to perform this operation when the
appliance is empty.
)
)
To carry out complete defrosting:
1. Disconnect the freezer from the electricity supply.
2. Remove any stored food, wrap in several layers of
newspaper and store in a cool place.
3. Leave the lid open.
4. To accelerate the defrosting process place a bowl
of hot (not boiling) water inside the freezer and
close the lid.
5. When defrosting is completed, dry the interior
thoroughly.
6. Turn the thermostat control back to a medium setting
between 3-4 and leave to run for at least 2 hours.
7. Replace the previously removed food.
IIm
mp
po
orrtta
an
ntt
A temperature rise of the frozen food packs during
defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from
the evaporator as this could damage the appliance
beyond repair.
Maintenance and Cleaning
Before any maintenance or cleaning is
carried out you must DISCONNECT the
appliance from the electricity supply
IIn
ntte
errn
na
all C
Clle
ea
an
niin
ng
g
Clean the inside and accessories with warm water
and bicarbonate of soda (5m1 to 0.5 litre of water).
Rinse and dry thoroughly.
NEVER use detergents, abrasive
powders, highly perfumed cleaning
products or wax polishes to clean the
interior as these will damage the
surface and leave a strong odour.
E
Ex
xtte
errn
na
all C
Clle
ea
an
niin
ng
g
Wash the outer cabinet with warm soapy water.
W
Wh
he
en
n tth
he
e A
Ap
pp
plliia
an
nc
ce
e iis
s n
no
ott iin
n U
Us
se
e
When the appliance is not in use for long periods,
disconnect from the electricity supply, empty all
foods and clean the appliance, leaving the lid open
to prevent unpleasant smells.
Something Not Working
If the appliance is not working correctly, please carry out the following checks before calling out an engineer.
If after all above checks there is still a fault, contact your local Service Force Centre.
In-guarantee customers should ensure that the above checks have been made, as the engineer will make a
charge if the fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee service calls.
Defect:
Freezer not cold
enough
Too much frost formed
Check if:
Temperature of stored foods
increases (becomes hotter).
Lid does not close
completely
Lot of moisture in the room
Goods packed poorly
Possible cause:
Plug not connected correctly
Defect in switch or fuse
Power failure
Lid in contact with goods in
freezer
Moisture from washing
machine, tumble-dryer, etc.
Lot of moisture from goods
Action:
Check plug and socket
Check fuse, call electrician
Wait until power is restored
Re-arrange goods, check that
lid closes correctly
Move freezer to a room with
less moisture, or air regularly
Re-pack goods, see under
“How to use”
