36
INSTALLATION
Caution
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance.
This will prevent it from becoming a death-trap for
a child.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature b18
°
C and +43
°
C (class T);
+18
°
C and +38
°
C (class ST); +16
°
C and +32
°
C (class
N); +10
°
C and +32
°
C (class SN).
The class of your appliance is shown on its rating plate.
Make sure that there is nothing at the back, at the
top and at the bottom of the appliance to obstruct
air circulation.
For safety reasons, minimum ventilation must be as
shown in the Figures:
Appliance positioned under overhanging kitchen
wall units (see Fig. 1-A).
Appliance positioned without overhanging kitchen
units (see Fig. 1-B).
Attention: keep ventilation openings clear of obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
Fig. 1
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure 2.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
NP002
100 mm
10 mm
10 mm
A
B
Fig. 2
Electrical connection
Before you plug the appliance into an A.C. mains
supply, make sure that the voltage and frequency
shown on the rating plate correspond to your home
supply.
A 6% fluctuation above or below the rated voltage is
admissible.
To adapt the appliance to other voltages, use an
autotransformer having a minimum output of
500 VA.
Important
It is essential that the appliance be connected to an
efficient earth tap. For this purpose the supply
cable plug incorporates a special earth contact. If
the sockets of your domestic wiring system are not
grounded, have the appliance connected to a
separate ground wire by a qualified electrician in
accordance with the existing safety regulations.
The manufacturer declines to accept any liability should
this safety rule not be observed.
This appliance complies with E.E.C. directive
No. 87/308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly. Do not use detergents which
will leave an odour or abrasive powders on the
interior, as these will damage the finish.
PR153
